HDD Recovery Software:\>

Contents > Procedures

3.2. Starting Active@ UNERASER

Start the program and display drive information using the following steps:

1. With power off, insert the prepared floppy disk into drive A:. Turn power on and boot from the floppy disk. The DOS screen with Command Prompt will appear.



2. Run Active@ UNERASER for DOS by typing this command, along with [Enter]:

 UNERASER.EXE

The UNERASER program window is displayed.

3. On the left side of the window all detected Hard Disk Drives (HDD) are listed.
   
   HDD Partitions and Logical Drives are displayed underneath in a tree formation, as shown in Figure 3-3, below. Deleted partitions and HDD space not occupied by partitions are listed as "Unallocated".

Figure 3-3 Logical Drive Information Display

4. Use the arrow keys to move the cursor over items on the list of drives. Positioning the cursor on a named drive, displays its information on the right side of the program window.

Previous < Contents > Next